laptop and a wrench

Erro

When selecting multiple point features and zooming into one of them, the Zoom to Selected tool does not go to the appropriate scale.

Última Publicação: November 1, 2019 ArcGIS Pro
Número de ID do Erro BUG-000125321
EnviadoSeptember 17, 2019
Última ModificaçãoNovember 21, 2025
Aplica-se àArcGIS Pro
Versão encontrada2.4
Sistema OperacionalWindows OS
Versão do Sistema Operacional2016 64 Bit
StatusKnown Limit

Informações Adicionais

This behavior is by design. Unlike line/polygon features, point locations only have a single XY(Z) so they do not have an "extent" that can be used to 'fill' the view. We can only center the view, and adjust the current scale. The problem is we cannot know what a 'good' scale is based on a single point. For example, the expected scale for a Cities layer (world extent) will be very different to the expected scale for a Fire Hydrants layer (in a small town), or an Extinguisher layer (inside a single building). Rather than attempting a guess (that is unlikely to be correct), we zoom the view in slightly from its current state as we center the point in the view. If you zoom into the map (manually) to a "good scale for the layer" *before* zooming to a single point feature, you'll get a better experience. You can also use Pan-To (instead of Zoom-To) for individual points. Note: Other users have raised this point before, so you're not alone. We'll take this bug report as a catalyst to investigate some other ideas for improving the general UX (and reducing confusion) of zooming-to-single-point.

Etapas para Reproduzir

ID do Erro: BUG-000125321

Software:

  • ArcGIS Pro

Seja notificado quando o status de um erro mudar

Baixe o Aplicativo de Suporte da Esri

Descubra mais sobre este tema

Obtenha ajuda de especialistas do ArcGIS

Entre em contato com Suporte Técnico

Baixe o Aplicativo de Suporte da Esri

Ir para as opções de download