LAS datasets created from LAS data do not display with the 3D point symbology in ArcGIS Pro.
Last Published: April 20, 2016ArcGIS Pro
Bug ID Number
BUG-000094042
Submitted
February 6, 2016
Last Modified
June 5, 2024
Applies to
ArcGIS Pro
Version found
1.1.1
Status
Non-Reproducible
This issue was not reproducible when tested by the development team. Issues may be given this status when they cannot be reproduced or are no longer relevant in a development version of the software, but a specific fix was not installed to address the issue. The issue's Additional Information section may contain further explanation.
Additional Information
ArcGIS Pro scenes have an elevation service that is not in ArcScene. The 3D points from the poe data are below that surface and are therefore obscured. Once removing the scene's ground elevation via the Scene Properties dialog the points show up.
There is no problem with the surface view (elevation, contours, slope, etc) of the LAS dataset because that is placed in the 2D category in the Table Of Contents and is draped on top of the scene's elevation source.