In ArcGIS Pro, when using a task that has a step with the Apply Symbology From Layer geoprocessing tool, the tool creates a separate layer with the applied symbology instead of applying the symbology to the existing layer.
Last Published: December 5, 2016ArcGIS Pro
Bug ID Number
BUG-000091674
Submitted
October 23, 2015
Last Modified
June 5, 2024
Applies to
ArcGIS Pro
Version found
1.1.1
Status
Non-Reproducible
This issue was not reproducible when tested by the development team. Issues may be given this status when they cannot be reproduced or are no longer relevant in a development version of the software, but a specific fix was not installed to address the issue. The issue's Additional Information section may contain further explanation.